Support - Whited00r Custom iOS for iPhone 2G, 3G & iPod Touch 1G & 2G > Hardware Problems - iPhone 2G, iPhone 3G or iPod Touch 1G & iPod Touch 2G

Wi-Fi keeps scanning / not working after WD installation


Hi there forum users,

Some WD users reported Wi-Fi failure after installing 4.x-6.x to their devices. I would like to clarify that this is not the fault of Whited00r. Whited00r supported devices are /old/ and Wi-Fi antennas do not last forever.

If you are experiencing trouble with your Wi-Fi after installing Whited00r:

1. Ensure that you did not restore from a backup in iTunes afer restoring to whited00r (in order to get your data back)
2. Rebooted twice
3. Ensure that you have not installed any tweaks or done any file system mods that may cause the problems
4. Restore to stock 3.1.3 to see if you still have an issue

* If you are still having issues after restoring to a stock apple firmware then you are experiencing a hardware issue. This is not the fault of Whited00r. Your device either needs repair or to be replaced.

WD PSA #1 (im going to start numbering these :P)
- JustinCase


[0] Message Index

Go to full version